Green Cubes Lithium Safeflex Series Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Camera Accessories Green Cubes Lithium Safeflex Series. Green Cubes Lithium Safeflex Series 2 pages.

Print Page

Green Cubes BDI

The BDI will flash the red light and beep if it needs attention. The

following conditions will trigger the alarm:

•

Overvoltage

•

Undervoltage

•

Over Temperature

•

Under Temperature

•

Low State of Charge

The truck operator should stay aware of the battery BDI while in

operation. When the battery gets low (<10%) the BDI will flash and

beep, signaling the battery must be charged. Once the battery is

empty it will cut power to the truck.

Charging Instructions

Batteries without internal chargers are charged either through

their main power connector (Euro or SB), a separate charge port,

or a charge port on the external of the truck. Make sure to use the

appropriate charge port when charging the battery.

Some of the smaller batteries have internal chargers. To charge

these batteries simply use the extension cord provided, and plug

the battery into a standard 110-120VAC outlet.

Use ONLY an approved and properly configured charger to charge

your SAFEFlex lithium-ion battery. Use of an unapproved or

incorrectly configured external charger may damage your battery

and void the warranty. The battery is designed for fast opportunity

charging and charges to specific voltage levels that may not be

programmed into your charger if it has not been approved or

properly configured.

ABOUT GREEN CUBES TECHNOLOGY

Green Cubes Technology harnesses over 30 years of industry experience to ensure we design, develop and deliver solutions for the

most challenging energy needs. We offer battery technology innovation, application design and performance management to drive

productivity, scalability and sustainability.

For more information, email [email protected]

or visit greencubestech.com

Opportunity Charging

The battery is designed for opportunity charging, and plugging it in

whenever not in use (breaks, lunch, and after hours) will lengthen

the runtime and lifetime of the battery. It is strongly recommend

the battery be plugged in for charging whenever it is not in use.

Operating Temperatures

Standard operational temperatures for the battery are:

Discharge: -4°F - 131°F

Charge: 32°F - 113°F

The battery may have additional options such as internal heaters, if

you wish to operate outside these temperatures.

Storage Temperatures

Storage (<1 month): -4°F - 113°F

Storage (>1 month): 41°F - 68°F

In addition, make sure to turn the battery off while in storage or

while equipment is waiting for deployment. Refer to our extended

storage instructions when planning to store the battery longer than

1 month.

Troubleshooting

If there is an error code on the BDI, follow the appropriate

instructions.

Over Temp: Allow the battery to cool.

Under Temp: Allow the battery to warm.

Over Voltage: Allow the BMS to bleed down the excessively

high voltage.

Under Voltage: Charge the battery.

If the battery has cut power and there is no error code (as detailed

in the Battery Discharge Indicator section) turn the battery off for

30 seconds, then turn it back on.

If this does not fix the issue, contact your dealer or Green Cubes

Technology Service directly at: (765) 831-8009

Thank you!

Data Sheet: 711355 Rev:A1