IKEA MIRAKULOS User Manual - Page 17

Browse online or download pdf User Manual for Oven IKEA MIRAKULOS. IKEA MIRAKULOS 28 pages. Built-in oven
Also for IKEA MIRAKULOS: User Manual (48 pages), Installation And User Manual (32 pages), Owner's Manual (28 pages), User Manual (28 pages), Manual (28 pages), Manual (32 pages), Manual (24 pages)

Print Page

ENGLISH

Installing the shelf supports

Install the shelf supports in the opposite se-

quence.

The rounded ends of the shelf supports

must point to the front.

Oven lamp

Warning! Be careful when you change

the oven lamp. There is a risk of

electrical shock.

Before you change the oven lamp:

• Deactivate the oven.

• Remove the fuses in the fuse box or deac-

tivate the circuit breaker.

Put a cloth on the bottom of the oven

to prevent damage to the oven light

and glass cover.

Always hold the halogen lamp with a cloth

to prevent grease residue from burning on

the lamp.

1. Turn the glass cover counterclockwise to

remove it.

2. Clean the glass cover.

3. Replace the oven light bulb with a 40

watt, 230 V (50 Hz), 350 °C heat resist-

ant oven light bulb (Connection type:

E14).

4. Install the glass cover.

Cleaning the water tank

Warning! Do not put water into the

water tank during the cleaning

procedure.

During the cleaning procedure, some

water can drip from the steam inlet on-

to the cavity of the oven. Put a dripping pan

on the shelf level directly below the steam

inlet to prevent water from falling onto the

bottom of the oven cavity.

After some time, you can have lime deposits

in your oven. To prevent this, clean the parts

of the oven that generate the steam. Empty

the tank after each steam cooking.

1. Fill in the water tank with 900 ml of wa-

ter and 50 ml of citric acid (five tea-

spoons). Deactivate the oven and wait

for approximately 60 minutes.

2. Activate the oven and set the Forced

Air + Steam function. Set the tempera-

ture 230 °C. Deactivate it after 25 mi-

nutes and let it cool down for 15 mi-

nutes.

3. Activate the oven and set the Forced

Air + Steam function. Set the tempera-

ture between 130 and 230 °C. Deacti-

vate it after 10 minutes. Let it cool

down and continue with the removal of

the tank contents (refer to "Emptying

the water tank").

4. Rinse the water tank and clean the re-

maining lime residue in the oven with a

cloth.

5. Clean the drain pipe by hand in warm

water with soap. To prevent damage,

do not use acids, sprays or similar

cleaning agents.

Types of water

• Soft water with low lime content - the

manufacturer recommends this because it

decreases the quantity of cleaning proce-

dures.

• Tap water - you can use it if your domes-

tic water supply has purifier or water

sweetener.

• Hard water with high lime content - it

does not have an effect on the perform-

ance of the appliance but it increases the

quantity of cleaning procedures.