IKEA ID5HHEXTQ00 Use & Care Manual - Page 11
Browse online or download pdf Use & Care Manual for Refrigerator IKEA ID5HHEXTQ00. IKEA ID5HHEXTQ00 40 pages.
Print Page
•
Has the ice melted around the auger (metal spiral) in the
ice bin? Dump the ice cubes and clean the ice bin.
Cut Hazard
Use a sturdy glass when dispensing
ice.
Failure to do so can result in cuts.
Is the ice dispenser stalling while dispensing "crushed"
ice? Change the ice button from "crushed" to "cubed." If
cubed ice dispenses correctly, depress the button for
"crushed" ice and begin dispensing again.
Has the dispenser arm been held in too long? Ice will stop
dispensing when the arm is held in too long. Wait 3 minutes
for dispenser motor to reset before using again.
The water dispenser will not operate properly
•
Freezer door closed completely? Close the door firmly. If it
does not close completely, see "The doors will not close
completely."
Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
Is the water pressure
at least 30 psi (207 kPa)? The water
pressure to the home determines the flow from the dispenser.
See "Water System Requirements."
Kink in the home water source line? Straighten the water
source line.
New installation? Flush and fill the water system.
Water filter installed on the refrigerator? The filter may be
clogged or incorrectly installed.
Is a reverse osmosis water filtration system connected to
your cold water supply? See "Water Supply Requirements"
in either the Installation Instructions or the Use & Care Guide.
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
•
Glass not being held under the dispenser
long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
New installation? Flush the water system. See "Water and
Ice Dispensers."
Recently changed water filter? Flush the water system. See
"Water and Ice Dispensers."
The dispenser water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
•
New installation?
Allow 24 hours after installation for the
water supply to cool completely.
•
Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.
•
Water not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.
Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
in either the Installation Instructions or
the Use & Care Guide.
WATERFILTER
CERTIFICATIONS
State of California
Department
of Health Services
Water Treatment Device
CertificateNumber
03- 1550
Datelssued:
Janualy
21,2003
rrademark/Model
Designa/ion
Replacement
Elements
Rated Caa_
Whirlpool
WF-NL240
NL240
240 gal
WhirJpool
WF-IAtJu
L400
400 gaI
Manufacturer:
WhMpt,ol
C6rp
N_mc
Organic
COntaminants
I no r t_al_[¢/Radio
Iol:ical
Contaminants
NiChe
Do not use *_ith water
that is microbiologically
unsafe
or of unknown
quality,
without
adequate
disinfection
hefnro or afterthe system.
11