Gandy 10T Series Operator's Manual - Page 3
Browse online or download pdf Operator's Manual for Spreader Gandy 10T Series. Gandy 10T Series 10 pages. Fertilizer spreader
Also for Gandy 10T Series: Operator's Manual (11 pages)
Print PageMaintenance of 10T Series Spreaders:
Lubrication of Spreader:
There are a total of 9 grease fittings on this spreader that need to be greased twice –a-day.
These 9 grease fittings are greased from the factory but double check that none were missed.
There is 1 on the optional hand shut-off, if used to be greased periodically as needed.
Left & Right Wheel Hubs & Wheel Hub Collars: (Three on Left End & Three on Right End)
The wheel hubs have a built-in grease reservoir and should be greased generously twice daily.
The front and rear collars need to be greased twice daily.
When properly lubricated grease should come out the parting line between the front and rear collars.
One Grease Fitting on Left & Right Wheel Hub
One Grease Fitting on Front & Rear Collar
Left & Right End & Center Bearing: (Three Total)
These three bearings need to be greased sparingly twice daily. Do not over grease as this will force excess
grease out into the spreader compartment and can cause interference with followability of material.
Grease Fitting Left & Right End Bearing
Grease Fitting Center Bearing
Knee Lever:
(only if using the manual shut-off lever)
Grease the knee lever mounted to the hitch by
the cam gauge periodically as needed.
~ 1 ~