IKEA MEDGANG Manual - Page 19
Browse online or download pdf Manual for Refrigerator IKEA MEDGANG. IKEA MEDGANG 48 pages. Refrigerator - freezer
Also for IKEA MEDGANG: Manual (48 pages), Manual (24 pages)
Print Page
ENGLISH
Problem
There is too much condensed
water on the rear wall of the
refrigerator.
Water flows inside the
refrigerator.
Water flows on the floor.
The doors does not close
completely.
Malfunction alarm
If the appliance malfunctions, the LED indicators
on the control panel will flash to indicate a fault
and the buzzer will sound. To switch the buzzer
1
off, press the
Alarm off button.
•
and
flash: Temperature sensor failure
of the refrigerator chamber
•
and
flash: Temperature sensor failure
of the freezer chamber
•
and
flash: Defrosting sensor failure of
the freezer chamber
•
and
flash: Communication failure
•
and
flash: Failure of ambient
temperature sensor
Possible Cause
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
The drain hole at the back of the
appliance is clogged.
Food products prevent water from
flowing into the water collector.
The door is not closed well.
The appliance tilts forward.
The drip pan cracks.
The defrost water drain is clogged.
The shelves are out of position.
The door gaskets are dirty.
The appliance is not level.
Closing the door
1.
2.
3. If necessary, replace the defective door
Replacing the lamp
The appliance is equipped with a lamp for
interior lighting.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Clean the drain hole with a piece
of wire.
Make sure that food products do
not touch the rear plate.
Refer to "Closing the door", or
refer to the troubleshooting item
below ("The door does not close
completely").
Tilt the appliance slightly backward
(a quarter-inch lower in the back).
Refer to the separate Assembly
Instructions for appliance level
adjustment.
Contact Authorised Service Centre
listed at the end of this manual.
Clean the drain hole with a piece
of wire.
Make sure the shelves are in
correct position. Refer to "Movable
shelves".
Clean the door gaskets.
Make sure the appliances
is installed in level. Refer to
"Levelling feet", or the separate
Assembly Instructions
If your appliance still is not working
properly after making the above checks,
contact the Authorised Service Centre. You
can find the list at the end of this manual.
Clean the door gaskets.
If necessary, adjust the door. Refer to the
separate Assembly Instructions.
gaskets. Contact the After Sales Service.
19
Solution