Decolav 5233-24 Use And Care Manual - Page 2

Browse online or download pdf Use And Care Manual for Indoor Furnishing Decolav 5233-24. Decolav 5233-24 3 pages.

Print Page

5233-24

Item # 5233-24

NOTE: Use DECOLAV

drain item #'s 9295-CP/SN/PN,

or 9297-CP/SN/PN for lavatories with overflow. DECOLAV

guarantee against leakage with other manufacturer drains.

BEFORE YOU BEGIN

• Prior to installation, unpack your new DECOLAV

Keep the product in its original package until you are ready to install it

• The wall must be square, plumb and level

• Shut the water supply off when replacing an existing fixture

• Observe all local plumbing and building codes

• It is recommended that this installation be done by a professional contractor

with a minimum of two people. Do not install this fixture alone

INSTALLING THE VANITY BASE

• Drawer pulls are attached on inside of drawers to ensure

safety during shipping

• Remove screws and attach drawer pulls to outside of drawers

• Measure the desired location of vanity and mark mounting hole

guidelines on wall and inside of top horizontal back rail of vanity base

• NOTE: TO PREVENT MOVEMENT AND PROTECT AGAINST POSSIBLE

LEAKAGE, IT IS RECOMMENDED THAT AT LEAST ONE WALL STUD IS

LOCATED IN THE AREA WHERE VANITY BODY IS TO BE INSTALLED

• Check alignment of mounting hole guidelines against vanity base to

ensure product is level (Adjust leg levelers if necessary, leg levelers are

located on the bottom of each leg)

• Drill mounting holes in finished wall

• Drill holes through vanity top horizontal back rail that match

the placement of the mounting holes in the finished wall.

• Attach anchors to mounting holes in finished wall (anchors not provided)

• Attach vanity base to finished wall using screws (screws not provided)

SECURING THE COUNTERTOP TO THE VANITY BASE

• Secure undermount lavatory to countertop as per manufacturer

installation instructions

• Apply sealant to top edge of vanity base

• Gently place countertop over vanity base

• Wipe away any excess sealant

• Apply sealant along rear edge of the countertop (close to finished wall)

• Gently lower backsplash in place ensuring that edges of backsplash

meet the edges of the countertop with no overhang

• Allow sealant to set before proceeding to install faucet, drain, and waste system

(not included), ensure that supply lines are secured tightly

• NOTE: DO NOT OVER TIGHTEN DRAIN. MAY RESULT IN DAMAGE

• Turn on water supply to faucet and check for leaks

ASSEMBLY INSTRUCTIONS

cannot

product and inspect it.

PLEASE CONTACT 1-866-DECOLAV (332-6528) FOR FURTHER ASSISTANCE

NOTE: Use DECOLAV

drain item #'s 9290-CP/SN/PN,

9296-CP/SN/PN, or 9298-CP/SN/PN for lavatories without

overflow. DECOLAV

cannot guarantee against leakage with

other manufacturer drains.

Figure 1

Figure 2

Top

horizontal

back rail

Apply

sealant

here

DECOLAV.COM