Gannet Pro User Manual - Page 15
Browse online or download pdf User Manual for Remote Control Gannet Pro. Gannet Pro 19 pages.
Also for Gannet Pro: Manual (5 pages)
Introduction of motors start/stop
1)
Pushing the throttle directly before take-off will not start the motor. Please turn the control mode
switch to the attitude mode position, keep the body stationary (7 seconds), and perform any of
the following four mast actions to start/stop the motor.
2)
If the attitude mode/GPS mode, if the throttle is not pushed to more than 10% after stating the
motor through the mast action, the remote controller will automatically enter the landing
judgment, and will automatically stop after about 3 seconds.
3)
Execute the above action to stop the motor and power off the aircraft (Note that you should not
try the above four actions during flying)
GPS attitude mode (the SWB switch in the top)
Select the area without high-rise buildings and stay away from the strong magnetic
environment, turn power on, LED red light flashes into the search star status, walt for about
30s, wait for LED red light flashes 6 times / red light does not flash when GPS has
Successfully positioned, the remote control mode switch SWB is set to the GPS mode, the
throttle stick is gently pushed to more than 50%, and the aircraft takes off to a certain height
to loosen the throttle stick. Currently, the aircraft automatically hovers. At this time, when
the user is activating the aileron and the lifter, the aircraft will maintain its current altitude
for flight.
Attitude mode (SWB switch in the middle)
The remote-control switch mode 5W8 switch is set to the attitude stabilization mode position,
the stick is unlocked, and the throttle midpoint is taken up. due to the advanced algorithm
of DJI NAZA-M-V2 flight control. In indoor or mindless environment, It is easy to hover or to
set a high maneuvering flight without controlling the throttle stick.
Note: When the flight control altitude stabilization mode is working, the UPS module does not
anticipate in the work.
Return mode (SWB switch in the bottom)
DJI NAZA-M-V2 flight control pre-flight master controller finding 6 or more satellites (red
flashing one time or not flash ) 0 seconds later, when the motor is started for the first time,
the main t controller will record this position as the return point. If the aircraft is more than
10 meters away from home, the aircraft will automatically rise to 20 meters and return.
Intelligent Direction Control Mode (SWC-IDC Switch)
INDTRODUCTION
10