IKEA DATID HGA4K User Manual - Page 10

Browse online or download pdf User Manual for Hob IKEA DATID HGA4K. IKEA DATID HGA4K 16 pages. Lagan
Also for IKEA DATID HGA4K: Instructions (4 pages), Manual (24 pages), Assembly Instructions Manual (20 pages), Manual (12 pages)

Print Page

ENGLISH

The connection of the cooktop to the gas pipe

network or gas cylinder must be made by

means of a rigid copper or steel pipe with fit-

tings complying with local regulations, or by

means of a continuous surface stainless steel

hose complying with local regulations.

If you see any abnormalities do not repair

the pipe, contact local After Sales Service

(refer to the Service chapter).

The connection must be installed correctly,

fixed into hob connection pipe. Otherwise it

will cause leakage of gas

Warning! Once the installation is

complete, check the perfect seal of every

pipe fixing. Use soapy water, never flame.

Electrical connection

Before connecting, check that the nominal volt-

age of the appliance stated on the rating

plate, corresponds to the available supply

voltage. Also, check the power rating of the

appliance and ensure that the wire is suitably

sized to suit the appliance power rating (refer

to the Technical data chapter).

The rating plate is located on the lower casing

of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a proper

plug, able to support the load marked on the

identification plate. To connect the plug to the

cable, follow the recommendation given in fol-

lowing figure.

Replacement of the connection cable

The replacement of the connection cable re-

quires the specific equipment of a technician.

In this case, only cable type H05V2V2-F T90

must be used. The cable section must be suit-

able to the voltage and the working temper-

ature. The yellow/green earth wire

approximately 2 cm longer than the brown (or

black) phase wire

The plug has to be fitted in a proper socket. If

connecting the appliance directly to the elec-

tric system, it is necessary that you install a

double pole switch between the appliance

and the electricity supply, with a minimum gap

of 3 mm between the switch contacts. The dou-

ble pole has to be of a type suitable for the

required load in compliance with the current

rules.

The connection cable has to be placed in order

that, in each part, it cannot reach a 90 °C tem-

perature. The blue neutral cable must be con-

nected to the terminal block marked with "N".

The brown (or black) phase cable (fitted in the

terminal block contact marked with "L") must

always be connected to the live phase.

(previous figure).

must be