Gantner 820679 Installation Instructions - Page 4
Browse online or download pdf Installation Instructions for Locks Gantner 820679. Gantner 820679 4 pages. Battery powered lock for mifare data carriers
Print Page
Startup and Configuration
Power supply
The GAT Lock 6010 F is powered by a 6 V battery (see technical data).
Use the battery key to open the battery compartment of the GAT Lock
6010 F as shown below.
Right-hinged door
Inserting the battery:
1. Ensure the battery polarity is correct.
2. Press the battery down into the compartment until it locks into place.
3. Swing the battery cover back over the battery compartment.
Battery contacts
2
1
Battery compartment contacts
NOTE! Insert the battery directly before the GAT Lock 6010 F is
mounted to avoid unnecessary battery usage. Only use the approved
battery listed in the "Accessories" section on page 1 (1 x Batterie 6V
Lithium 2CR5, Part No.: 125273).
Valid from February 27
, 2017 • Technical data subject to modification without notice.
th
4
DB_GAT-LOCK6010F--EN_21.indd • Part No.: 985287
Left-hinged door
Battery key
Configuration
The GAT Lock 6010 F can be configured via PC/laptop and configuration
software or by using the system data carriers included in the GAT Lock
Basic Set 6000 F. A detailed description of the configuration process is
available in the user manual.
For PC/laptop configuration, connect the programming cable to the jack
in the battery compartment of the GAT Lock 6010 F as shown below.
Connect the other end of the programming cable to a spare USB port on
the PC/laptop.
Communication is activated using the service data carrier. The programming
cable and service data carrier are included in the GAT Lock Basic Set
6000 F.
Safety Instructions
- The installation and maintenance of this device must be
performed by trained, qualified personnel.
- All applicable safety and accident prevention regulations
must be observed.
- Safety devices must not be removed.
- Please observe the technical data of the device specified in
this datasheet.
- The device must be disconnected from the power supply
prior to installation, assembly or dismantling.
PC/laptop with
configuration software
USB connector (type A)
Programming cable
Jack
Battery compartment
Battery
www.gantner.com