Century Helicopter Products Predator Max 90 Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Toy Century Helicopter Products Predator Max 90. Century Helicopter Products Predator Max 90 20 pages.
Also for Century Helicopter Products Predator Max 90: Instruction Manual (20 pages)

Print Page

Century Helicopter Products Predator Max 90 Instruction Manual

Clutch

Shoe

Fan

Assembly

Attach the clutch shoe with the M3 button socket bolts using

threadlock.

#HW6007

Clutch Shaft

Bearing Block

M3x12 Socket Screw x 2

Clean the top of the clutchbell gear and inside of the upper

bearing with alcohol. Apply a small amount of permanent

locktight around the top edge of the clutch gear where it will

contact the bearing. Press the clutch shaft bearing block in

place. Attach the long bearing block with M3x12 socket

screws but do not tighten at this time.

#HI3205

Servo

Mount

Tabs

Prepare the rear ccpm servo, attach the rubber servo tabs and

the eyelets from the top of the servo.

#HW6045

Lower

Long

Bearing

Block

Rubber servo tabs,

eyelets and screws

provided with radio.

#HW6045

Lower

Short

Bearing Block

(top surface is

flat)

#HW6013

Clutch Bell Assembly 10T

#HW6013A

Clutch Bell Assembly 11T

#HW6014

Replacement Clutch Lining

Clean the clutchbell and inside of the bearing with alcohol.

Apply a small amount of permanent locktight around the top

15mm edge of the aluminum clutchbell where it will contact the

bearing. Ensure the bearing is against the clutchbell. Press

evenly and firmly as this is a very tight fit.

#HW6042

Main Shaft Bearing Block

26mm

Threaded Hex

Spacer

Attach the clutchbell and bearing block assembly, main shaft

bearing block and front hex threaded spacer with M3x8 socket

screws to the left upper side frame. Do not use locktight at this

time. Notice the countersunk hole below the bearing is on the

outside.

Servo

output

shaft to

rear of

helicopter.

Install the rear ccpm servo into the inside of the right side of

the upper side frames. Be careful, look for the countersunk

hole below the bearing is on the outside.

#HW6110

Upper left Side

Frame

M3x8 Socket Screws x 8