IKEA hushalla framtid Manual - Page 21

Browse online or download pdf Manual for Hob IKEA hushalla framtid. IKEA hushalla framtid 28 pages.
Also for IKEA hushalla framtid: Manual (16 pages)

Print Page

ENGLISH

Electrical connection

Prior to connecting

Check that the voltage on the rating plate

corresponds to the voltage in your home.

The rating plate is on the front edge of the

oven (visible when the door is open).

Do not remove the microwave inlet

protection plates located on the side of the

oven cavity walls. They prevent grease and

food particles from entering the microwave

inlet channels.

Ensure the oven cavity is empty before

mounting.

Ensure that the appliance is not damaged.

Check that the oven door closes firmly

against the door support and that the

internal door seal is not damaged. Empty

the oven and clean the interior with a soft,

damp cloth. Do not operate this appliance

if it has a damaged mains cord or plug, if

it is not working properly, or if it has been

damaged or dropped. Do not immerse the

mains cord or plug in water. Keep the cord

away from hot surfaces. Electrical shock, fire

or other hazards may result.

After connecting

The oven can be operated only if the oven

door is firmly closed.

Regulation require that the appliance is

earthed.

The manufacturer will accept no

responsibility for injury to persons, animals

or damage to objects arising from the

non-observance of this requirement.

The manufacturers are not liable for any

problems caused by the user's failure to

observe these instructions.

Failure to observe these instructions may

lead to risks. The Manufacturer declines any

liability for injury to persons or animals or

damage to property if these advices and

precautions are not respected.

CAUTION: The appliance is not intended to

be operated by means of an external timer

or separate remote control system.

After installation, the electrical components

must not be accessible to the user.

For installation to comply with current

safety regulations, an omnipolar switch with

minimum contact gap of 3mm is required.

WARNING : The power cable must be long

enough for connecting the appliance, once

fitted in its housing, to the main power

supply.

Do not pull the power supply cable.

If the power cable is damaged it must

be replaced with an identical one. The

power cable must only be replaced by a

qualified technician in compliance with the

manufacturer instruction and current safety

regulations. Contact an authorized service

center.

Do not operate this appliance if it has a

damaged mains cord or plug, if it is not

working properly, or if it has been damaged

or dropped. Do not immerse the mains cord

or plug in water. Keep the cord away from

hot surfaces.

Do not touch the appliance with any wet

part of the body and do not operate it when

barefoot.

For appliances with fitted plug, if the plug is

not suitable for you socket outlet, contact a

qualified technician.

Do not use extension leads, multiple sockets

or adapters. Do not connect the appliance

to a socket which can be operated by

remote control.