IKEA MATMASSIG Manual - Page 38

Browse online or download pdf Manual for Hob IKEA MATMASSIG. IKEA MATMASSIG 44 pages.
Also for IKEA MATMASSIG: Manual (28 pages), Manual (24 pages), Manual (44 pages), Manual (44 pages), Manual (28 pages), Manual (48 pages), Manual (36 pages), Manual (28 pages), Manual (29 pages), Manual (12 pages), Manual (48 pages)

Print Page

ENGLISH

3. Using a socket spanner 7, unscrew and

remove the injectors, and replace them

with the ones required for the type of

gas in use.

4. Reassemble the parts, following the

same procedure backwards.

Place the label with relevant

information for new type of gas

close to the supply pipe before

sealing the appliance. If the

appliance is already sealed please

stick it directly on the user

manual booklet, after Technical

data chapter, and close to the

rating plate drawing.

You can find this label in package

supplied with appliance.

If the feeding gas pressure is

different or variable from the

required one, you must install an

appropriate pressure adjuster,

which is not supplied with the

product. If needed, it must be

ordered separately from the local

After Sales Service Provider, refer

to the Service chapter. The

pressure adjuster must be fitted

on gas supply pipe, in compliance

with the rules of the force.

The rating plate is located below the surface

of the casing.

Adjusting flame level

When you install the hob, it is necessary to

check the minimum flame setting:

1. Turn the gas tap to the maximum

position and ignite.

2. Set the gas tap to the minimum flame

position and turn the control knob from

minimum to maximum several times. If

the flame is unstable or extinguished,

follow the procedure further.

3. Re-ignite the burner and set to

minimum.

4. Remove the control knob and the gasket.

Warning! Pay attention not to

damage the gasket. Do not

use sharp tool to remove it.

5. To adjust, use a thin bladed screwdriver

and turn the adjustment screw until the

flame is steady and does not extinguish

when the knob is turned from minimum

to maximum, and vice versa (see

following picture).

6. Repeat this procedure for all burners.

7. Reassemble the gasket and the knobs.