ENGLISH
Warning! For safety reasons, do not
clean the appliance with steam
blasters or high-pressure cleaners.
Warning! Do not use abrasive
cleaners, steel wool pads or acids, they
will damage the appliance.
To remove any food remains wash the
enamelled elements, "caps" and "crowns",
with warm soapy water.
Stainless steel elements wash with water,
and then dry with a soft cloth.
What to do if...
Problem
There is no spark when
lighting the gas
The flame is blowing out im-
mediately after lightning
The gas ring burns unevenly
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
Technical data
Hob dimensions
built in height
Possible cause
There is no electrical supply
There is no electrical supply
Burner cap and Crown are
placed uneven
Thermocouple is not heated
enough
Burner crown is blocked with
food residues
width
depth
This model is equipped with electrical igni-
tion, it is obtained through ceramic "candle"
with electrode.
Keep them well clean to avoid difficult light-
ning.
Periodically ask your local Service Cen-
tre to check the conditions of the gas
supply pipe and the pressure adjuster, if it is
fitted (this service is not free of charge).
After cleaning, be sure to wipe dry with a
soft cloth.
Check that the unit is plug-
ged in and the electrical
supply is switched on.
Check the house electric in-
stallation fuse.
Check the burner cap and
crown have been replaced
correctly, e.g. after cleaning.
After lightning the flame,
keep the knob pushed for
about 5 sec.
Check the main injector is
not blocked and the burner
crown is clear of food parti-
cles.
If you operated the appliance wrongly,
or the installation was not carried out
by a registered engineer, the visit from the
customer service technician or dealer may
not take place free of charge, even during
the warranty period.
290 mm
520 mm
45 mm
7
Remedy
Print Page