IKEA DATID Manual - Page 12
Browse online or download pdf Manual for Ventilation Hood IKEA DATID. IKEA DATID 24 pages. 30" (76.2 cm) wall-mount canopy range hood
Also for IKEA DATID: User Manual (16 pages), Installation Manual (12 pages), Installation Instructions And Use & Care Manual (18 pages)
Print Page
ENGLISH
Installation
After unpacking the hob, make sure that it
has not been damaged during transport. In
the event of problems, contact the dealer or
your nearest After-sales Service.
Technical information for the installer
-
This product can be embedded in a
worktop 20 to 50 mm thick.
-
If there is no oven beneath the hob,
insert a separator panel that has a
surface at least equal to the opening
in the work surface. This panel must be
positioned in no case less than 20 mm
from the bottom of the hob.
-
Before installation, make sure that:
-
the local gas delivery conditions (nature
and pressure) are compatible with the
settings of the hob (see the rating plate
and injector table);
-
the outer surfaces of the furniture or
appliances adjacent to the hob are heat
resistant according to local regulations;
-
This appliance is not connected to a
fume exhaust device. It shall be installed
in accordance with current installation
regulations. Particular attention shall
be given to the relevant requirement
regarding ventilation.
-
Combustion products are discharged
outdoors through specific hoods or wall
and/or window mounted electrical fans.
Gas connection
This operation must be performed by a
qualified technician.
The gas supply system must comply with
local regulations to the relavant gas
standard.
-
You can find specific local regulations for
some countries in the paragraph
-
"Reference to Local Regulations". If no
information concerning your Country is
given, please ask details to a qualified
technician.
-
The connection of the hob to the gas
pipe network or gas cylinder must be
made by means of a rigid copper or
steel pipe with fittings complying with
local regulations, or by means of a
flexible hose assemby complying with
local regulations. The maximum length
of the hose is 2 linear metres.
-
The flexible hose assembly must be
an Australian approved Class B or D
flexible hose with 10mm I.D.
-
The hose should not be subjected
to abrasion, kinking or permanent
deformation and should be able to be
inspected along its entire length. Unions
compatible with the hose fittings must
be used and connections tested for gas
leaks.
- IMPORTANT: if a flexible hose assembly
is used, it must be installed so as not to
touch any mobile part of the furniture.
It must pass through an area where
there are no obstructions and where it is
possible to inspect it on all its length.
-
After connection to the gas supply, check
for leaks with soapy water. Light up the
burners and turn the knobs from max
12