IKEA IHW8303WS0 Installation Instructions And Use & Care Manual - Page 8
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood IKEA IHW8303WS0. IKEA IHW8303WS0 28 pages. 30"(76.2cm) wall-mount canopy range hood
Also for IKEA IHW8303WS0: Use And Care Manual (32 pages)
Print Page
Vented Installations
Only
1. Fit vent system over transition piece.
2. Seal connection with clamps.
Non-vented
(recirculating}
Installation
1. Assemble the 3 parts of the deflector with 2 - 3.5 x 6.5 screws
provided. The assembled deflector should be sized to fit the
width of the vent cover bracket installed earlier.
C
B
Mc <® Eecff ccl Connect on
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
1. Disconnect
power.
2. Remove terminal box cover.
3. Remove the knockout.
2=
A. Vent cover bracket width
B. Deflector
C. 3.5 x 6.5 mm screws
Connect the deflector to the vent cover bracket using
4 - 3.5 x 6.5 screws provided.
I
I
I
A
B
A. Knockout
B. Terminal box cover
4. Install the UL listed or CSA approved strain relief.
B
A. Vent cover bracket
B. 3.5 x 6.5 mm screws
3. Measure length of 8" (20.3 cm) vent needed to connect the
transition to the deflector.
NOTE: Vent should fit up inside deflector a minimum of
1" (2.5 cm).
4. Install vent between the transition and the deflector.
5. Seal all connections
with clamps.
F
A. V2" conduit
B. Terminal box cover
C. UL fisted or CSA approved strain relief
D. Green (or bare) wire connected
to yellow-green
wire
E. White wires
F. Black wires
5. Run 3 wires, black, white and green (14 AWG), in V2" conduit
from service panel to terminal box.
6. Use UL listed wire connectors
and connect black wires
together.
7. Use UL listed wire connectors
and connect white wires
together.
8