IKEA IHW8305WS0 Installation Instructions And Use & Care Manual - Page 10

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood IKEA IHW8305WS0. IKEA IHW8305WS0 28 pages. 30"(76.2cm) wall-mount canopy

For non-vented (recirculating) installations
1. Turn off blower and lights. Check that halogen lamps are
cool.
2. Remove the metal grease filters by pushing handle toward
the rear and pull downward.
3,
4.
5.
Pull filter toward front.
Set the filter face down on a cover such as a towel.
Install charcoal filter on rear of metal filter with metal wires
provided
in filter packaging.
A. Metal wires
B. Charcoal filter
C. Metal filter
To replace the metal grease filters:
1. Insert back edge of filter into rear channel of the filter
opening.
2. Push handle toward the rear and push filter up.
3. Pull filter toward the front and insert into front channel.
Check Range Hood Operation
A
123 ®@
0 0 0
B
C
A. Light button
B. Indicator light
C. Pc wer/speed button
1. Press the "A" button. The light should turn on.
2. Press the "C" button to select the power/speed.
Keep the
button pressed for 2 seconds to go to OFF status.
3. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
4. Disconnect
power supply.
5. Check that the wiring is correct.
6. Replace all parts and panels before operating.
7. Reconnect power.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
RANGE HOOD USE
The canopy hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Range Hood Control
Panel
The range hood controls are located on the front side of the
canopy.
123
• 'T'
A
B
C
A. Light button
B. Indicator light
C. Speed button
Operating
the light
1. Press the "A" button to turn on the light.
2. Press the "A" button again to turn off the light.
Operating
the blower and adjusting
blower speed
1. Press the "C" button to select the power/speed.
2. Keep the button pressed for 2 seconds to go to OFF status.
10