CEP CT63 User Manual - Page 9
Browse online or download pdf User Manual for Touch terminals CEP CT63. CEP CT63 20 pages.
2
Electrical Description
The modem uses the following standard connectors:
RJ11 6-way (power connector)
Mini USB (USB 2.0)
SIM card reader
FME male coaxial jack (antenna connector)
Sub-D female socket, 9 pin (RS232 serial port)
2.1 Power Connector
An RJ11 6-way connector, as shown and described below, serves as a means of supplying and
controlling DC power to the modem. It is necessary to connect an external power supply, since the
available power on the USB port is not sufficient to run the modem.
The supply voltage, VCC, required by the modem is 5V - 32V DC. Application of the supply voltage does
not switch the modem on. To do so an additional active-high control signal, TO_IN, must be applied for
> 1 second.
Please see chapter "3.1 Switching ON the modem" for further important details about TO_IN and
power supply requirements, especially if TO_IN is applied in parallel to VCC.
VCC and GND are reverse-polarity and over-voltage protected.
This does not apply for the GND on the antenna connector if this coax GND / shield are
connected to your applications ground-plane.
PIN: -> 6
5 4 3 2 1
Figure 4: RJ11 Pin Connector
9