Ganz ZC-DT4039NHA Operation Manual - Page 4
Browse online or download pdf Operation Manual for Security Camera Ganz ZC-DT4039NHA. Ganz ZC-DT4039NHA 4 pages. Vandal resistant camera
Print Page
Installing the dome enclosure
1. Remove the dome cover
Use the supplied Torx driver to loosen (but not remove) the four cover screws.
The screws are captive and will be retained in the lid.
2. Use the template to mark and prepare the mounting area
The vandal resistant dome was designed to maintain their IP and NEMA ratings independent of the
install method chosen. Therefore, all mounting access positions are sealed until they are ready to be
used. For example when surface-mounting the housing, first knock out the screw access holes that
correspond to the template marks "T1". This can be done using a crosshead screwdriver.
3. Open the required knock-out panel
Carefully drill (or tap out) either the base knock-out (E1) or internal side knock-out (E3) to the size
required to allow cable entry. When surface mounting and using the side knock-out (E3), open the
cut out (E4) within the outer ring to the required size by cutting away excess material with a hole
cutter, sharp knife or side cutters.
4. Mount the dome enclosure
Using one of the mounting schemes discussed overleaf (methods for mounting the enclosure), fix
the dome enclosure (and outer ring, if necessary) in place. When flush mounting or surface
mounting using the outer ring, ensure that the large rubber gasket (E6) is in place under the lip of
the dome enclosure.
IMPORTANT: If the dome is being mounted externally using
the four base holes, use the supplied rubber o-rings within each
of the four mounting holes of the dome base to ensure moisture
resistant seals (see Fig. C overleaf).
5. Connect the wiring
Feed the preconnected main lead (that terminates in
connections F1 and F2) through the knock-out hole and
connect it to your video out and power in cables. A wire-ended
adaptor lead (F8) is supplied for use with power supply cables
that are not terminated with an appropriate power connector
(For 12 VDC operation: Connect the red lead to +ve and the
black lead to -ve. For 24 VAC connection, polarity is not important).
IMPORTANT: The power supply must be Class 2 certified.
IMPORTANT: If the dome is being mounted externally, use a suitable sealant around the cable
access hole to ensure a moisture resistant seal.
6. Fit the camera assembly
Connect the camera to the fly-connector (F4). For ZC-DWT4039 series camera only: also connect
the OSD lead (F6) between the camera and the middle socket of the smaller circuit board.
Place the complete camera assembly (G1) onto the three mounting pillars within the enclosure.
Note: Gimbal screws are supplied with both the housing and the camera assembly (when supplied
separately), therefore, you should have three screws left over.
7. Remove the camera liner
Lift the camera liner (H1) from the chassis (H2) to provide full access to the camera.
8. Adjust the camera position and test
Rotate and pan the camera chassis to the required position and then tighten the camera chassis
locking screws.
Note: For specific camera adjustments (i.e. focusing and settings), please see the Camera Sheet.
9. Replace the camera liner
Carefully fit the camera liner (J1) over the focused camera so that it is fully seated on the top ring of
the camera chassis (J2) and provides an unobstructed view for the camera lens.
10. Replace the dome cover
Replace the dome cover (four small internal ribs within the cover locate within four corresponding
index slots (E6) within the enclosure body; these restrict the lid to only four possible orientations
and ensure that the cover screw holes are correctly aligned). Use the supplied Torx bit to tighten
the four cover screws - DO NOT OVERTIGHTEN.