IKEA LAGAN Manual - Page 18

Browse online or download pdf Manual for Ventilation Hood IKEA LAGAN. IKEA LAGAN 24 pages. Examples of the load of the basket
Also for IKEA LAGAN: Assembly Instructions Manual (8 pages), User Manual (20 pages), User Manual (16 pages), User Manual (20 pages), Instructions Manual (48 pages), User Manual (16 pages), User Manual (24 pages), Manual (28 pages), Instruction Manual (24 pages), User Manual (24 pages), Manual (24 pages), Manual (4 pages), User Manual (12 pages), Manual (24 pages), Assembly Instructions Manual (20 pages), Installation Manual (20 pages), Manual (28 pages), Manual (32 pages), Manual (44 pages), Manual (16 pages), Manual (16 pages), Manual (24 pages), Manual (28 pages), Manual (28 pages), User Manual (28 pages), Manual (40 pages), Manual (48 pages), Use & Care Manual (25 pages), Manual (44 pages), Manual (40 pages), Manual (28 pages), Manual (28 pages), User Manual (24 pages), Manual (48 pages), User Manual (16 pages), Installation Instructions Manual (18 pages), Manual (48 pages), Quick Start Manual (4 pages), Installation Instructions Manual (16 pages), Manual (28 pages), Manual (28 pages), Manual (44 pages), Manual (48 pages), Manual (16 pages), Manual (32 pages), Manual (24 pages), Manual (25 pages), Manual (18 pages), User Manual (28 pages), Manual (44 pages), Manual (32 pages), Manual (18 pages), Manual (48 pages), Manual (29 pages), Manual (29 pages), Manual (34 pages), Installation Instructions Manual (42 pages)

Print Page

ENGLISH

Gas setting conversion

You can use this model with

natural gas. However, you can

convert it for use with other

gases, providing the correct

injectors.

For more information on injector

replacement, refer to the Technical data

chapter.

Warning! Conversion or

replacement can only be

performed by a authorised

technician.

To replace injectors:

1. Remove pan support.

2. Remove burner cap and crown.

3. Using a socket spanner 7, unscrew and

remove the injectors, and replace them

with the ones required for the type of

gas in use.

4. Reassemble the parts, following the

same procedure backwards.

Place the label with relevant

information for new type of gas

close to the supply pipe before

sealing the appliance. If the

appliance is already sealed please

stick it directly on the user

manual booklet, after Technical

data chapter, and close to the

rating plate drawing.

You can find this label in package

supplied with appliance.

If the feeding gas pressure is

different or variable from the

required one, you must install an

appropriate pressure adjuster,

which is not supplied with the

product. If needed, it must be

ordered separately from the local

After Sales Service Provider, refer

to the Service chapter. The

pressure adjuster must be fitted

on gas supply pipe, in compliance

with the rules of the force.

The rating plate is located below the surface

of the casing.

Adjusting flame level

When you install the hob, it is necessary to

check the minimum flame setting:

1. Turn the gas tap to the maximum

position and ignite.

2. Set the gas tap to the minimum flame

position and turn the control knob from

minimum to maximum several times. If

the flame is unstable or extinguished,

follow the procedure further.

3. Re-ignite the burner and set to

minimum.

4. Remove the control knob .

5. To adjust, use a thin bladed screwdriver

and turn the adjustment screw until the

flame is steady and does not extinguish

when the knob is turned from minimum

to maximum, and vice versa (see

following picture).

6. Repeat this procedure for all burners.

7. Reassemble the knobs.