Avantco 178SSPTM4812 User Manual - Page 6
Browse online or download pdf User Manual for Refrigerator Avantco 178SSPTM4812. Avantco 178SSPTM4812 16 pages. Prep tables
Print Page
•
Select a location away from heat and moisture-generating equipment.
- Ambient temperatures above 75 degrees Fahrenheit may cause the compressor to malfunction.
- Using this unit in consistent ambient temperatures above 75 degrees Fahrenheit will void the warranty.
Any exposure to ambient temperatures of 90 degrees Fahrenheit or above will also void the warranty.
- Do not install the unit inside a closet or alcove.
•
For optimal performance, 3" of clearance is required around all louvered or vented panels, to allow for
proper air flow.
- Component failure due to improper installation is not covered under the warranty.
Electrical
•
Please ensure that the required voltage is being supplied at all times.
•
The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate
over-current projection. Please refer to the electrical requirements on the unit's nameplate.
•
This unit should have its own dedicated outlet.
•
Do not use extention cords.
•
Ensure the unit is not resting on or against the electrical cord.
•
If the unit is not in use for a long period of time, please unplug the unit from the outlet.
•
To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.
•
After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could
cause damage to the compressor.
Adjusting Temperature
Your new refrigerator is already factory-set to run at
optimum temperatures for food safety and should
require no adjustments.
Refrigerators are set to cycle between a minimum temperature of 33 degrees Fahrenheit and a maximum
temperature of 40 degrees Fahrenheit.
Adjusting the temperature changes the minimum temperature your unit will run at. Your unit will not run
constantly at this setting. To change it, follow these instructions:
Digital Control Units
•
Hold "SET" for 1 sec. The display will flash the current minimum temperature.
•
Use the arrow buttons to adjust the minimum temperature you want it to run at.
•
Press "SET" again to save your settings.
Always remember to calculate the differential if you change the minimum temperature setting. The cabinet
temperature will fluctuate up to +7 degrees over your set minimum temperature as the compressor runs and
shuts off. Setting the temperature too high will result in unsafe maximum temperatures and possible health
code violations.
www.AvantcoRefrigeration.com
6
User Manual
Refrigerated Prep Tables
set