IKEA W10258591A Installation Instructions And Use & Care Manual - Page 8
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood IKEA W10258591A. IKEA W10258591A 24 pages. 30" (76.2 cm) vented range hood
Print Page
3.
Use saber or keyhole saw to cut a 7" (17.8 cm) diameter
opening.
71/4" (18.4 cm) diam.
cabinet cutouts
*From wall, not
cabinet frame
4. Install vent through the vent opening in upper cabinet or wall.
Complete venting system according to the selected venting
method. See "Venting Requirements"
section.
5. Use caulking to seal exterior wall or roof opening around the
cap.
1.
2.
c tsge blo
Remove terminal box cover.
A. Terminal box cover
Depending on your installation remove either back or top
wiring knockout.
A. Wiring hole knockouts
3.
Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
4.
5.
A. Keyhole slot
Use V8" (3 mm) drill bit and drill 4 pilot holes as shown.
A
A. Drill pilot hole
Install the four #10 x 5/8"mounting screws in pilot holes.
Leave about V4" (6.4 cm) space between screw heads and
cabinet to slide range hood into place.
\\\\\\\\\\
_f
1/'4"
(6.4 mm)
Electrical
Shock Hazard
Disconnect
power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
6.
For Direct Wire Installations:
•
Install a UL listed or CSA approved strain relief.
A
A. UL listed or CSA approved strain relief
•
Pull about 12" (30 cm) of wire through wall or cabinet and
into opening.
For Power Supply Installations:
•
Follow instructions
included with power supply cord kit
marked for range hoods.
8