Avantco 178UDD4HCS User Manual - Page 8
Browse online or download pdf User Manual for Kitchen Appliances Avantco 178UDD4HCS. Avantco 178UDD4HCS 19 pages. Beer dispensers
Also for Avantco 178UDD4HCS: User Manual (19 pages), User Manual (19 pages)
Print Page
Drain Instructions:
On direct draws, the drain is located at the front of the cabinet. (UDD1 & UDD1S drain into a bottle located
inside the unit) To plumb in the drain, connect ½" PVC pipe to the barbed fitting supplied with the unit. If
you would prefer to drain the beer inside the unit (for mobility or where a drain can't be found):
•
Use a screwdriver to remove the drain bracket.
•
Pull the drain hose so that it is inside the unit.
•
Attach a bottle to the drain hose inside the unit.
•
Plug the created hole at the bottom of the unit.
Start-up
•
Dial temperature controls set at the no. 4 position gives refrigerators an approximate temperature of
35°F. Digital temperature controls are programmed to operate between 33°F and 40°F with no
adjustments. Allow unit to function several hours, completely cooling the cabinet before changing the
control settings.
•
Excessive tampering with the control could lead to service difficulties. Should it ever become necessary
to replace temperature control, be sure it is ordered from your Avantco dealer or recommended
service agent.
•
Good air flow in your unit is critical. Be careful to load product so that it neither presses against the back
wall, nor comes within four inches of the evaporator housing. Refrigerated air off the coil must circulate
down the back wall.
RECOMMENDATION:
Before loading product, we recommend you run your Avantco unit empty for 2-3 days. This allows
you to be sure the electrical wiring and installation are correct and no shipping damage has
occurred. Remember, the Ready Kitchen Warranty does not cover product loss!
www.AvantcoRefrigeration.com
8
User Manual
Beer Dispensers