IKEA UDDARP Manual - Page 9

Browse online or download pdf Manual for Dishwasher IKEA UDDARP. IKEA UDDARP 29 pages.
Also for IKEA UDDARP: Installation Instructions Manual (25 pages), Manual (28 pages)

Print Page

ENGLISH

What to do if...

Your washing machine is equipped with various automatic safety and feedback functions.

They enable failures and needed maintenance to be detected and indicated accordingly.

Problem

The washing machine does not turn on.

The wash cycle does not start.

The washing machine does not fill with

water (the message "h2o" is shown on the

display). "Beep" sound every 5 seconds.

The washing machine loads and drains

water continuously.

The washing machine does not drain or

does not spin.

The washing machine vibrates excessively

during the spin cycle.

The washing machine leaks water.

The machine is locked and the display

flashes, indicating an error code (e.g. F-01,

F-..).

Too much foam is formed.

Door is locked, with or without failure

indication, and the programme does not

run.

Technical data

220-240

IKEA

UDDARP

5 / 8

Rated

Voltage (V)

Brand

Model

capacity

Frequency

(kg)

Possible causes / Solutions:

• The plug is not inserted into the electrical outlet, or not enough to make contact.

• There has been a power failure.

• The "ON/OFF" button has not been pressed.

• The "Start/Pause" button has not been pressed.

• The water tap is not open.

• A "Start delay" has been set.

• The door is not fully closed.

• The water intake hose is not connected to the tap.

• The hose is bent.

• The water tap is not open.

• The mains water supply has been shut off.

• There is not enough pressure.

• The "Start/Pause" button has not been pressed.

• The drain hose has not been installed at 65 to 100 cm from the ground.

• The end of the drain hose is immersed in water.

• The drain connector on the wall does not have an air vent.

• If the problem persists after having performed these checks, close the water tap,

shut off the washing machine, and call the After-sales service. If the dwelling

is located on one of the uppermost floors of a building, a siphon effect can

sometimes occur, thus causing the washing machine to load and drain water

continuously. Special anti-siphon valves are available on the market to prevent

these types of problems.

• The programme does not include the draining function: with certain

programmes it must be activated manually.

• The drain hose is bent.

• The drain line is obstructed.

• At the time of installation, the drum was not properly unblocked.

• The washing machine is not level.

• The washing machine is squeezed between furniture and the wall.

• The water intake hose has not been tightened properly.

• The detergent dispenser is clogged.

• The drain hose has not been properly fastened.

• Shut off the machine, disconnect the plug from the outlet, and wait about 1

minute before turning it back on.

• If the problem persists, call the After-sales service.

• The detergent is not compatible with the washing machine (it must bear the

wording "for washing machines", "for hand washing and washing machines", or

something similar).

• The dosage was excessive.

• Door is locked in case of power breakdown. Programme will continue

automatically as soon as the mains is available again.

• Washing machine is in a standstill. Programme will continue automatically after

the origin of the standstill does not persist anymore.

E / C

0,531 / 0,078

Energy

Energy consump-

efficiency

tion in kWh per

class for the

kg per cycle, for

complete

the wash and dry

(Hz)

cycle/wash-

cycle/washing

ing cycle

cycle

To download the full version visit www.ikea.com

266 / 63

62 / 48

Weighted en-

Weighted water

ergy consump-

consumption

tion in kWh per

per cycle in litre

100 complete

for the complete

efficienty

cycle/washing

cycles

cycle

0,5

Power consumption in

Noise emis-

Spin-

sions during

drying

standby

programme

delay start

mode

class

(W)

phase) dB(A)

Noise

eco 40-60

Emission

Class

(spinning