GAPOSA EMITTO SMART16 Installer Manual - Page 5

Browse online or download pdf Installer Manual for Transmitter GAPOSA EMITTO SMART16. GAPOSA EMITTO SMART16 7 pages. 16 channels hand held display remote with timer
Also for GAPOSA EMITTO SMART16: Quick Start Manual (12 pages)

Print Page

Manual Mode: The transmitter works only by sending up stop and down commands to channels or groups

by manually pressing the button on the transmitter.

Automatic Mode: The transmitter will operate with manual control as well as executing schedules auto-

matically.

Random Mode: The transmitter will operate with manual control and all schedules will execute with a

delay from 0-30 minutes. For example, if the schedule is set to go off at 8:00, when in random mode, the

schedule will go off anywhere between 8:00 and 8:30.

PROGRAMMING TRANSMITTER (Fig.1)

CAUTION: If more motors with receiver have to be installed, it is important to power up only one motor at time

during the first programming session, in order to avoid any interferences with the others.

1. Power up the motor to be programmed.

2. Hold SYNC pressed until the motor starts moving.

3. Check the rotation of the motor, then release SYNC (the motor stops).

4. Within 5 seconds press the corresponding button (i.e. UP if the motor rotates upwards or DOWN if vice

versa).

In this way the transmitter has been programmed and the rotation of the motor has been synchronized.

ADDING TRANSMITTER (Fig.1)

2. Hold SYNC pressed of a transmitter already paired until the motor starts moving.

3. Check the rotation of the motor, then release SYNC (the motor stops).

4. Within 5 seconds press the corresponding button (i.e. UP if the motor rotates upwards or DOWN if vice

versa) on the new transmitter being added.

Additional transmitter is now added

FIG. 1

OFF

CHECKING/CHANGING DIRECTION (Fig.2)

IMPORTANT: change direction must be performed before starting limit setting otherwise limits must be reset.

Press

UP or

DOWN button the motor should go UP or DOWN, otherwise to change direction:

1. Press and hold SYNC button till the motor starts moving

2. Press

STOP button: The motor makes a brief jog.

Direction of the motor has been reversed.

FIG. 2