ALIBI ALI-CD700VF Quick Installation Manual
Browse online or download pdf Quick Installation Manual for Security Camera ALIBI ALI-CD700VF. ALIBI ALI-CD700VF 3 pages. Ali-cd700 series infrared turret cameras
Print Page
ALI-CD700 Series Infrared Turret
Cameras Quick Installation Guide
For Products: ALI-CD700, ALI-CD700G (gray), ALI-CD700VF, ALI-CD700VFG (gray)
The ALIBI ALI-CD700 series turret cameras include a new generation sensor with high sensitivity and
advanced circuit design technology. They feature high resolution, low image distortion and low noise
features which makes them suitable for surveillance and image processing systems.
Features
High resolution color sensor: 700 TV Lines
•
IR LED enables the day/night surveillance
•
2.8 ~ 12 mm Varifocal lens (ALI-CD700VF series only)
•
IR cut filter auto switch
•
True day/night
•
ATW brings high color rendition
•
Auto electronic shutter control adapts to different surveillance environments
•
Auto gain control, adaptive brightness
•
High SNR for high-quality image
•
12 Vdc power
•
Weather protection: IP66 rated
•
Mounting
plate
Clip plate
Enclosure
IR array
Lens
Camera
module
ALI-CD700 camera assembly
Clip plate
Base
assembly
IR array
Lens
Zoom
adjust
ALI-CD700VF camera assembly
www.observint.com
1
Video BNC
Connector
Camera drop cable connectors (all ALI-CD700 series cameras)
What's in the box
Camera assembly
•
Security L- wrench
•
Mounting screws and wall inserts
•
This manual
•
Drill template
•
ALI-CD700 (left) and ALI-CD700VF (right) drill templates
Tools you need
To install the camera, you will need:
12 Vdc power source. See Specifications for voltage and wattage requirements.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Video and power extension cable
•
CCTV video setup monitor (optional)
•
Installation
Before installation:
Make sure that the device is in good condition and all the assembly parts are included.
•
Mounting
Check the specification of the products for the installation environment.
plate
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
•
provide the rated voltage and wattage for the camera. See the Specifications section.
During installation:
Enclosure
Camera Lens: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
•
Camera
array shield becomes soiled, clean it only with approved products. See the
module
Monitor impedance: Set the monitor impedance switch to 75 Ω.
•
Power supply: Camera drop cable: The camera drop cable includes two connectors:
•
Video BNC connector: For transmission of the video signal across a coax (75 Ω) extension
—
cable.
Power connector: When applying Vdc power, observe the power polarity. See the picture
—
Focus
above for connector polarity configuration.
adjust
1.
Using the drill template provided with your camera, mark the location of the screws that anchor the
base plate to the mounting surface. If you are routing the drop cable through base, also mark the
position of the hole for the drop cable.
2.
Drill holes for the screws that anchor the base to the ceiling. The mounting hardware provided is
appropriate for most surfaces. However, depending on the surface materials, more appropriate
fasteners may be required.
Power
Connector
section.
Cleaning
ALI-CD700_CQ
7/8/14