CORNING LSE 6710 Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Laboratory Equipment CORNING LSE 6710. CORNING LSE 6710 12 pages. Digital vortexer
Also for CORNING LSE 6710: Instruction Manual (9 pages)

Print Page

RPM (Digital Load Independent)

Motion/Orbit Size

Timer

Maximum Load

Dimensions (W x L x H)

Weight

NOTE: The supply cord shall be with PE conductor and cross section at least 3 x 1.00 mm

3 x AWG 18 (USA/CANADA).

The unit can be connected to external installation with overcurrent protective device max.

value 16A or 20A (USA/CANADA). This device is intended for use in a basic electromagnetic

environment (Basic, class B), and it is in compliance with IEC 61326-1:2020. The device may

experience a restart during overvoltage events (surges) or voltage interruptions in mains

power supply.

The Corning® LSE™ Digital Vortexer is designed to be safe at least when operated under the

following conditions:

Indoor use

Altitude up to 2,000 meters

Pollution Degree 2

4.0 Installation

4.1 Unpacking

Before starting installation, carefully examine the vortexer for damage or missing parts.

Open the box and lift the device together with the inner packing out of the box.

Remove the inner packing and check that the vortexer has not been visibly damaged during

transportation. Keep the packing material until you are sure that the vortexer works properly.

Check information on the rear data label and verify the following are correct:

Model

•

Serial number

•

Electrical rating

•

Should any kind of damage have occurred during transportation, contact the carrier

immediately. The carrier is responsible for shipping damage.

CO R N I N G L S E D I G I TA L VO RT E X E R

100 to 1,200 rpm in 10 rpm intervals

Circular, 3 mm

30 sec. to 99 min. 50 sec. in 10-second steps (under 10 min.

in 1-second steps), timer HOLD function

4.4 lbs. (2 kg)

10.3 x 13.3 x 5.1 in. (26.2 x 33.7 x 13 cm)

16 lbs. (7.3 kg)