CORNING LSE 6876-SB Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Laboratory Equipment CORNING LSE 6876-SB. CORNING LSE 6876-SB 12 pages. Digital dry bath heater

Print Page

Caution: HOT surfaces that can burn or cause injury.

Use of this product in any manner not specified by the manufacturer or

modification of the product may cause injury and/or may void the warranty.

3.0 Installation

Upon unpacking the Corning® LSE™ Digital Dry Bath Heater, inspect for

damage. Shipping damage is the responsibility of the carrier. Inspect that

the following are present: instruction manual, data logger software, line

cord, block lifter, lid, USB cable.

Select a location that is dry and not subject to drafts or moving air from

heating or air conditioning vents or air blown by other equipment. Place

the unit on a flat, preferably non-flammable, surface. Allow sufficient room

around the unit for access and cooling (six inches minimum on all sides is

suggested). Plug the unit into a properly grounded outlet. Using the lifter,

insert the block(s) into the well. The unit is now ready for use.

On/Off rocker switch, located on the back of the unit: Turns primary power

on and off.

Start/Stop LED, red: Used to activate or stop the unit. Illuminates when unit

is in heating mode; off in temperature set mode.

Time LED, green: Used to set or select Time mode. This LED light indicates

running Time mode.

Heating LED, red: Illuminates when unit is in Heating mode and unit is

applying heat to the block. This LED is on continuously during heat-up and

cycles on and off when the unit is at the set temperature.

Temperature Up arrow key: Raises set temperature when unit is in Set mode.

Temperature Down arrow key: Lowers set temperature when unit is in Set mode

Timer Up arrow key: Raises set time when unit is in Set mode.

Timer Down arrow key: Lowers set time when unit is in Set mode.