Makita 4322 Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Power Tool Makita 4322. Makita 4322 19 pages.
Also for Makita 4322: Instruction Manual (17 pages)

Print Page

Front flush cuts

Loosen the bolt on the back of the tool

base with the hex wrench, then move the

tool base all the way back. Then tighten the

bolt to secure the tool base.

Base

cutouts

Cutouts can be made with either of two methods A or B.

A) Boring a starting hole: For internal cut-

outs without a lead-in cut from an edge,

pre-drill a starting hole 12 mm (1/2") or

more in diameter. Insert the blade into

this hole to start your cut.

B) Plung cutting: You need not bore a start-

ing hole or make a lead-in cut if you

carefully do as follows.

1. Tilt the tool up on the front edge of

the base with the blade point posi-

tioned just above the workpiece sur-

face.

2. Apply pressure to the tool so that the

front edge of the base will not move

when you switch on the tool and

gently lower the back end of the tool

slowly.

3. As the blade pierces the workpiece, slowly lower the base of the tool down onto the

4. Complete the cut in the normal manner.

workpiece surface.