Makita 4324 Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Power Tool Makita 4324. Makita 4324 16 pages. Jig saw
Also for Makita 4324: Parts Manual (2 pages), Instruction Manual (19 pages), Instruction Manual (10 pages)

Print Page

cutouts

Cutouts can be made with either of two methods A

or 0

A) Boring a starting hole: For internal cut-

outs without a lead-in cut from an edge,

pre-drill a starting hole 12 mm (1/2") or

more in diameter. Insert the blade into

this hole

start your cut.

B) Plunge cutting You need not bore

starting hole or make a lead-in cut if you

carefully do as follows

1 Tilt the tool up on the front edge of

the base with the blade point posi-

tioned just above the workpiece sur-

face

2 Apply pressure to the tool

so that the

front edge of the base will not move

when you switch on the tool and gen-

tly lower the back end of the tool

3 As the blade pierces the workpiece, slowly lower the base of the tool down onto the

slowly

workpiece surface.

4. Complete the cut in the normal manner.

Finishing edges

To trim edges or make dimensional adjust-

ments, run the blade lightly along the cut

edges.