Makita 4326M Instruction Manual - Page 8
Browse online or download pdf Instruction Manual for Power Tool Makita 4326M. Makita 4326M 13 pages. Jig saw
Also for Makita 4326M: Specifications (2 pages), Technical Information (7 pages)
Print Page
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
► 1 . Starting hole
For internal cutouts without a lead-in cut from an
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start
your cut.
B) Plunge cutting
You need not bore a starting hole or make a
lead-in cut if you carefully do as follows.
(1)
Tilt the tool up on the front edge of the base
with the blade point positioned just above the
workpiece surface.
(2)
Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
(3)
As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
(4)
Complete the cut in the normal manner.
Finishing edges
1
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
Dust extraction
1
► 1 . Dust cover 2. Hose
Clean cutting operations can be performed by connect-
ing this tool to a Makita vacuum cleaner. Insert the hose
of the vacuum cleaner into the hole at the rear of the
tool. Lower the dust cover before operation.
NOTE:
•
Dust extraction cannot be performed when
making bevel cuts.
8 ENGLISH
2