CORNING Centrix Jumper Routing - Page 7

Browse online or download pdf Jumper Routing for Network Hardware CORNING Centrix. CORNING Centrix 20 pages. System splitter/cwdm cassette installation
Also for CORNING Centrix: Instructions Manual (8 pages), Quick Start Manual (2 pages)

Print Page

2. Jumper Routing and Slack Storage when Cross-

connecting in the Same Frame

When cross-connecting jumpers within one frame, use a single-fiber

jumper length of 4 m (13 ft) to eliminate the need to cut jumpers to a

specific length.

• Determine location of jumper termination.

• Connect both ends of the jumpers to the selected adapters, then route

slack under both transition spools and over the highest hub that can

be reached without pulling on the jumper.

• If the termination is within the same frame, refer to

jumper termination is within another frame, skip to

2.1.

Connecting Housing 1 to Housing 6

TPA-4450

STANDARD RECOMMENDED PROCEDURE 003-960 | ISSUE 4 | OCTObER 2017 | PAGE 5 OF 18

Cross-connecting

in the same frame

Connecting housing 1

to housing 6

Top five housings assigned

to active equipment (EQ)

bottom five housings assigned

to outside plant (OSP)

Unless noted other-

wise, jumper routing

configurations

are the same for

front and rear

cable access frames.

Figure

5. If the

Section

Figure 5