Makita 4350CT Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Power Tool Makita 4350CT. Makita 4350CT 13 pages. Jig saw
Also for Makita 4350CT: Specifications (2 pages), Instruction Manual (13 pages), Instruction Manual (13 pages), Technical Information (14 pages)

Print Page

► 1 . Fence guide 2. Threaded knob 3. Circular guide

When cutting circles or arcs of 170 mm or less in

radius, install the rip fence as follows.

Insert the rip fence into the rectangular hole on the

side of the base with the fence guide facing up.

Insert the circular guide pin through either of the

two holes on the fence guide. Screw the threaded

knob onto the pin to secure the pin.

Now slide the rip fence to the desired cutting

radius, and tighten the bolt to secure it in place.

Then move the base all the way forward.

NOTE:

•

Always use blades No. B-17, B-18, B-26 or B-27

when cutting circles or arcs.

Guide rail adapter set (accessory)

When cutting parallel and uniform width or cutting

straight, the use of the guide rail and the guide rail

adapter will assure the production of fast and clean

cuts.

To install the guide rail adapter, insert the rule bar into

the square hole of the base as far as it goes. Secure the

bolt with the hex wrench securely.

► 1 . Bolt 2. Rule bar

Install the guide rail adapter on the rail of the guide rail.

Insert the rule bar into the square hole of the guide rail

adapter. Put the base to the side of the guide rail, and

secure the bolt securely.

► 1 . Screw 2. Guide rail adapter 3. Guide rail

CAUTION:

•

Always use blades No. B-8, B-13, B-16, B-17 or

58 when using the guide rail and the guide rail

adapter.

Cover plate

► 1 . Cover plate 2. Base

Use the cover plate when cutting decorative veneers,

plastics, etc. It protects sensitive or delicate surfaces

from damage. Fit it on the back of the tool base.

10 ENGLISH