Makita 4350CT Instruction Manual - Page 6
Browse online or download pdf Instruction Manual for Power Tool Makita 4350CT. Makita 4350CT 13 pages. Jig saw
Also for Makita 4350CT: Specifications (2 pages), Instruction Manual (13 pages), Instruction Manual (13 pages), Technical Information (14 pages)
Print Page
Workpiece to be cut
Wood
Mild steel
Stainless steel
Aluminum
Plastics
CAUTION:
•
The speed adjusting dial can be turned only as
far as 5 and back to 1. Do not force it past 5 or
1, or the speed adjusting function may no longer
work.
The tools equipped with electronic function are easy to
operate because of the following features.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start feature
Safety and soft start because of suppressed starting
shock.
Lighting up the lamps
For 4350FCT only
CAUTION:
•
Do not look in the light or see the source of light
directly.
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Number on adjusting dial
4 - 5
3 - 5
3 - 4
3 - 5
1 - 4
Installing or removing saw blade
CAUTION:
•
Always clean out all chips or foreign matter
adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tighten-
ing of the blade, resulting in a serious personal
injury.
•
Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
•
Tighten the saw blade securely. Failure to do so
may cause a serious injury.
•
When you remove the saw blade, be careful not
to hurt your fingers with the top of the blade or
the tips of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
► 1 . Tool opener
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
1
2
► 1 . Blade clamp 2. Jig saw blade 3. Protrusions
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
•
Do not open the tool opener excessively, or it
may cause tool damage.
6 ENGLISH
3