HIKVISION DS-7208HVI-S Installation Manual

Browse online or download pdf Installation Manual for DVR HIKVISION DS-7208HVI-S. HIKVISION DS-7208HVI-S 4 pages. Embedded net dvr
Also for HIKVISION DS-7208HVI-S: Technical Manual (11 pages)

Print Page

Installation Guide

DS-7208 & 7216HVI-S Series DVR

Verify Contents

Verify that the package contents are correct by checking the

items against the packing list.

Note:

Please contact your dealer for damaged or missing

items.

DVR Pre-Installation

The DS-7208&7216 Series DVRs are highly advanced

surveillance equipment that should be installed with care.

Please take into consideration the following precautionary

steps before installation of the DVR.

1. Keep all liquids away from the DVR.

2. Install the DVR in a well-ventilated and dust-free area.

3. Ensure environmental conditions meet factory

specifications.

4. Install a manufacturer recommended HDD.

DVR Installation

During the installation of the DVR:

1. Use brackets for rack mounting.

2. Ensure there is ample room for audio and video cables.

3. When installing cables, ensure that the bend radius of the

cables are no less than five times than it's' diameter.

4. Connect both the alarm and RS-485 cable.

5. Allow at least 2cm (~0.75in) of space between racks

mounted devices.

6. Ensure the DVR is grounded.

7. Environmental temperature should be within the range of

-10º C ~ 55º C, 14º F ~ 131º F.

8. Environmental humidity should be within the range of

10% ~ 90%.

Hard Disk Installation

Rear Panel Diagram

Before installing a hard disk drive (HDD), please make sure

the power is disconnected from the DVR. A manufacturer

recommended HDD should be used for this installation.

Tools Required: Phillips screwdriver.

To install a HDD on your DVR:

5. Re-install the lid of the DVR and fasten screws.

Installation Guide - DS-7208 & 7216HVI-S Series DVR

Remove the lid of the DVR by unfastening the screws

on the back.

Install the HDD on the chassis

Connect the HDD to the motherboard of the DVR with

the included data cable.

Connect the power cable to the HDD.