Avantco Equipment 177MG12 User Manual - Page 3

Browse online or download pdf User Manual for Meat Grinder Avantco Equipment 177MG12. Avantco Equipment 177MG12 7 pages.

Print Page
Avantco Equipment 177MG12 User Manual

General Safety Warnings

NEVER operate Grinder without the Tray secured in place.
To avoid serious or fatal injury, NEVER reach into any Grinder inlet.
ALWAYS use the Stomper to push meat into the Grinder Head.
ALWAYS disconnect the Grinder from the power source before any disassembly for cleaning
or any other reason.
ALWAYS disconnect the Grinder from power source or outlet before any cleaning/maintenance.
1.
Plug the Grinder into a standard 120 Volt, 60 Hz wall outlet.
2.
DO NOT USE the Grinder if the Power Cord, Plug or any other parts are damaged.
3.
Do not allow the Power Cord to drape into your work area.
4.
NEVER use any accessories or parts from other manufacturers. Doing so will VOID YOUR
5.
WARRANTY and may cause fire, electrical shock or injury.
DO NOT SUBMERGE THE GRINDER MOTOR INTO LIQUID OR WATER. BE SURE THE GRINDER
6.
IS DISCONNECTED FROM THE POWER SOURCE BEFORE CLEANING.
KEEP FINGERS CLEAR of the Auger and Cutting Blades AT ALL TIMES. NEVER REACH INTO THE
7.
GRINDER, doing so may cause serious injury. ALWAYS USE THE PROVIDED STOMPER, NEVER
FEED FOOD BY HAND.
NEVER use fingers to scrape food away from the Grinding Plate while the Grinder is in operation.
8.
SEVERE INJURY MAY RESULT.
NEVER OPERATE THE GRINDER UNATTENDED.
9.
Tie back loose hair and clothing, and roll up long sleeves before operating the Grinder. REMOVE
10.
ties, rings, watches, bracelets, or other jewelry before operating the Grinder.
SAVE THESE INSTRUCTIONS
11.

CLEANING INSTRUCTIONS

See above warnings and ensure the unit is removed from the power source.
1.
Separate the head from the body using the thumbscrew located on top of the body.
2.
Remove the tray and unscrew the front guard. The grinding plate, auger and knife may now be
3.
removed.
Wash all parts that have come in contact with meat in hot soapy water. Cleaning should be done
4.
immediately after use. DO NOT immerse the motor body in water.
Rinse the Grinder parts with clean hot water, then dry them using a cloth. DO NOT place them in the
5.
dishwasher.
Fully lubricate the Head, Plates and the Knife with a food grade silicone spray before and after each
6.
use.
Clean the Motor Cover and Gear Housing with a damp towel and wipe dry. quickly.
7.
Make sure the grinder and all components are completely dry before assembling or storing.
8.
www.AvantcoEquipment.com
User Manual
3