CORNING UAT3 Operating Instructions Manual - Page 14

Browse online or download pdf Operating Instructions Manual for Tools CORNING UAT3. CORNING UAT3 18 pages.

Print Page

b. Carefully pull the scored tube apart. Remove both sections of

the tube at the other ring cut (Figure 19).

7.11

For gel-filled cables, use a lint free tissue or cloth to wipe the

filling compound from each ribbon or fiber. If cleaner ribbons or fibers

are desired, filling compound remover may be used.

7.12

Separate and clean the fiber bundles or ribbons by following

the appropriate cable stripping procedure.

7.13

Mount the cable in the prepared closure or terminal end

cap along with the drop cable (Figure 20). Refer to the instruction

manual provided with the closure for complete loading procedures.

BE EXTREMELY CAREFUL NOT TO DAMAGE THE EXPOSED FIBERS OR

RIBBONS DURING THIS STEP.

Distribution cable bers

Preparing the Fibers for Splicing

Complete the cable splicing and installation according to the

instructions for the particular terminal or closure being installed.

Drop cable ber (s)

Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 14 of 18

Figure 19

Figure 20