Avantes AvaLight-LED Operation And Installation Manual - Page 9

Browse online or download pdf Operation And Installation Manual for Lighting Equipment Avantes AvaLight-LED. Avantes AvaLight-LED 13 pages. Light sources

Print Page

4. Changing the LED of the AvaLight-LED

1. Disconnect the power connector from the socket.

2. Remove the screw protection caps on the front side.

3. Remove the screws with the torx screwdriver (Torx T10)

4. Remove the Hex UNC screws of the DB15 connector from the back side.

5. Take out the front plate and electronics board.

6. Untighten the screws from the LED holder and LED connector.

7. Slightly bend the electrical wires out of the LED connector.

8. Take out the LED from the LED holder.

9. Replace the LED, make sure the Anode and Cathode are connected in the same way and LED

legs make no short circuit. Extension of the legs may be needed depending on the LED type.

Cathode

Anode

10. Tighten the screws from the LED holder and LED connector.

11. Put back the electronics board and front plate back into the housing.

12. Put back the hex UNC screws and the screws in the front plate.

13. Put back the protection caps on the front side.

14. Apply power to see if the LED is illuminating.

Revision: 1-00

www.avantes.com

[email protected]