Avantgarde LBWC-30SB2 Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Wine Cooler Avantgarde LBWC-30SB2. Avantgarde LBWC-30SB2 10 pages. Built-in wine cooler
Also for Avantgarde LBWC-30SB2: Instruction Manual (19 pages)

Print Page

3. INSTALLATION INSTRUCTIONS

BEFORE U SING Y OUR A PPLIANCE

Remove the exterior and interior packing.

•

Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will

•

reduce the possibility of a malfunction in the cooling system from improper handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

•

INSTALLATION S PECIFICATIONS

This appliance requires a standard 115 Volt A.C. /50Hz electrical outlet with three-prong ground

•

This appliance is designed to be installed built-in or free standing.

•

Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct

•

sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient

temperature below 68°F (20°C) or above 90°F (32°C) will hinder the performance of this appliance. This

unit is not designed for use in a garage or any other outside installation.

Avoid locating the appliance in moist areas.

•

Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any circumstances

•

cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or

grounding should be directed toward a certified electrician or an authorized service center. This unit is not

designed to be installed in an RV or used with an inverter.

After p lugging t he a ppliance i nto a w all o utlet, a llow t he u nit t o c ool d own f or 3 ~

•

4 h ours b efore p lacing w ine b ottles o r b everage c ans i n t he a ppliance.

This w ine c ooler c ome w ith a djustable l egs ( in t he f ront) t o h elp l evel t he u nit

•

BUILT-‐IN I NSTALLATION

The cutout dimension illustrated in figure (A) allows for door swing and access to the pull-out shelves when

installed as a built-in appliance. If installing between frameless cabinets, a ½" wide filler strip or side panel may

be needed on hinge side. The filler strip will act as a spacer between the appliance case and adjacent cabinet

door swing. The width of the opening must include the filter panels.

Note:

The door should protrude at least 1" beyond the surrounding cabinets.

23"Including d oor

24 ½ " ( Including h andle)

21 ¼ " ( cabinet)

33 3 /4"

15"

15-3/4"

min