Jameco Electronics 2168923 Quick Start Manual

Browse online or download pdf Quick Start Manual for Pest Control Jameco Electronics 2168923. Jameco Electronics 2168923 3 pages. Low cost deer deterrent

Print Page
Low Cost Deer Deterrent
PART NO. 2168923
This kit contains a water-proof enclosure that will need to have four 1/4 inch holes drilled in it to accommodate the LED holders. The
PCB will need to be assembled and installed to the box with Velcro. A buzzer and battery pack will also be attached with Velcro. The
program for the PIC12F675 is pre-programmed and can be changed if desired.
Time Required: 30 minutes depending on experience
Experience Level: Intermediate
Required tools and parts:
Soldering Iron/Solder
#1 Philips Screw Driver
Optional: PIC programmer for PIC12F675
1/4 inch drill bit and drill
Bill of Materials:
Qty
Jameco SKU
1
141841
1
140695
1
1217519
1
332672
1
216152
1
223781
4
124927
1
615769
4
2077061
4
2157175
4
2157167
4
417501
1
112206
1
2125325
1
35991
1
--
Step 1 - Assemble PCB
Completely install all the electronic components to the printed circuit board (PCB). Assemble the PCB as according to the schematic
making sure to use the LED connectors to attach the LEDs to the board. Pay special attention to the orientation of the LED polarity!
Solder the black wire to the pad closest to the flat part of the symbol on the board. Clip LED leads and insert into LED connectors.
Experiment with the length so that the LED fits snugly into the connector and the mount.
Make sure to solder the IC socket to the PCB, not the PIC chip itself. The PIC will be inserted into the socket after programming.
Make sure to match the diode stripe on the PCB with the diode component.
Component Name
Water Proof Enclosure
Buzzer
FET
Capacitor
Battery Holder
PIC Micro-controller
LED Mount
Silicone Sealant
SuperBrite LED White
Resistor 1/4W - 100 ohm
Resisitor 1/4W 10K Ohm
LED Connector
8-pin IC Socket
Velcro
Diode
Printed Circuit Board