Makita 9911 Instruction Manual - Page 6
Browse online or download pdf Instruction Manual for Power Tool Makita 9911. Makita 9911 8 pages. 76mm
Also for Makita 9911: Instruction Manual (17 pages), Parts Breakdown (3 pages), Instruction Manual (13 pages), Instruction Manual (8 pages), Technical Information (5 pages), Instruction Manual (17 pages)
Print Page
Switch on the tool and make sure that the belt is aligned
properly. If the edge of the belt extends beyond the edge
of the steel plate or the edge of the belt retracts more
than 8 mm away from the edge of the steel plate, use the
adjusting screw to adjust the belt tracking.
Dust bag
2
003387
Attach the dust bag onto the dust spout. The dust spout
is tapered. When attaching the dust bag, push it onto the
dust spout firmly as far as it will go to prevent it from
coming off during operation.
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty the
dust bag of its contents, tapping it lightly so as to remove
particles adhering to the insides which might hamper
further collection.
NOTE:
If you connect a Makita vacuum cleaner to this tool,
•
more efficient and cleaner operations can be
performed.
Connecting to Makita vacuum cleaner
1
3
004050
Cleaner sanding operations can be performed by
connecting the belt sander to Makita vacuum cleaner.
When connecting to Makita vacuum cleaner, an optional
hose 28 mm in inner diameter is necessary.
1. Dust spout
1
2. Dust bag
1. Optional hose
28 mm in inner
2
diameter
2. Hose of vacuum
cleaner
3. Vacuum cleaner
OPERATION
Sanding operation
004232
CAUTION:
The tool should not be in contact with the
•
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish or damage of the
belt may result.
Hold the tool firmly with both hands. Turn the tool on and
wait until it attains full speed. Then gently place the tool
on the workpiece surface. Keep the belt flush with the
workpiece at all times and move the tool back and forth.
Never force the tool. The weight of the tool applies
adequate pressure. Excessive pressure may cause
stalling, overheating of the motor, burning of the
workpiece and possible kickback.
Clamps (optional accessory)
This machine can be operated in the inverted position.
To do so, secure the machine to a stable workbench with
two clamps.
1
004140
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
6
1. Clamps