Makita AN942 Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Power Tool Makita AN942. Makita AN942 17 pages. Pneumatic construction nailer
Also for Makita AN942: Instruction Manual (20 pages), Parts Breakdown (3 pages), Technical Information (7 pages)

Print Page
Makita AN942 Instruction Manual
1. Nail stopper
1
2
1. Air socket
2. Air fitting
OPERATION
1
2
8
•
Depress the nail stopper and remove the strip of nails from the
004303
magazine.
1
Connecting air hose
•
Lock the trigger. Slip the air socket of the air hose onto the air fitting on
004304
the nailer. Be sure that the air socket locks firmly into position when
installed onto the air fitting. A hose coupling must be installed on or near
the tool in such a way that the pressure reservoir will discharge at the
time the air supply coupling is disconnected.
CAUTION:
•
Make sure all safety systems are in working order before operation.
1.
To drive a nail, you may place the contact element against the workpiece
and pull the trigger, or
2.
Pull the trigger first and then place the contact element against the work-
piece.
•
No. 1 method is for intermittent nailing, when you wish to drive a nail
004305
carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
•
However when the tool is set to the "Intermittent Nailing" mode, WITH
THE TRIGGER HELD IN A HALF-PULLED POSITION, an unexpected
nailing could occur, if contact element is allowed to re-contact against the
workpiece or the other surface under the influence of recoil.
In order to avoid this unexpected nailing, perform as follows;
A.
Do not place the contact element against the workpiece with excessive
force.
004306
B.
Pull the trigger fully and hold it on for 1-2 seconds after nailing.