E-Service Nayax Installation Manual - Page 7
Browse online or download pdf Installation Manual for Payment Terminal E-Service Nayax. E-Service Nayax 18 pages.
Print Page
3.
Enable 10p coins for testing
On the large circuit board on the opposite side, locate the four switches marked 'S2', as seen circled
in red in figure 7. Flip the fourth switch to the on position, as seen in figure 8.
4.
Test the newly activated software.
Test the software by dropping a 10p coin, it should give change for the same value that the Nayax tap
value should be, i.e £5, £10 or £20. Insert all other coins and notes and check the change given is correct.
If the change given is correct, close the control module, re-insert the note validator and proceed to
section 5. If the change is incorrect or you encounter other errors, replace the old software chip and call
E-Service support on 01707 280 050.
Nayax Installation Guide
Figure 7
Figure 8
7