Makita BCS550 Technical Information - Page 4

Browse online or download pdf Technical Information for Power Tool Makita BCS550. Makita BCS550 13 pages. Cordless metal cutter 136mm (5-3/8")
Also for Makita BCS550: Parts Breakdown (3 pages), Instruction Manual (13 pages), Instruction Manual (12 pages), Instruction Manual (10 pages)

Print Page

epair

[3] DISASSEMBLY/ASSEMBLY

[3] -1. Base (cont.)

ASSEMBLING

1) Do the reverse of the disassembling steps.

2) After assembling Base to the machine, adjust the following portion for smooth adjustment of cut depth:

A. Pan head screw M5 in the hinge portion of Base

Must be tightened so that the machine can move along

Depth guide smoothly without rattling. (Figs. 4 and 5)

B. Lever 40

Must be installed so that it can be locked at an angle of

between 0 and 30 degrees from the centerline towards

Switch side when the cut depth is set to the maximum.

(Fig. 6)

[3] -2. Safety Cover Complete and Bearing Box Section

DISASSEMBLING

1) Remove Blade cover and Rubber sleeve. (Figs. 2 and 3)

2) By removing Retaining ring WR-26 with 1R291, the following parts can be removed (Fig. 7):

two Spacers (one on the outside and the other on the inside of Safety cover), Safety cover complete,

Tension spring 3, Thickness ring

Note 1: Safety cover complete can be separated from Blade case by unhooking the end of Tension spring 3 from

Blade case.

Note 2: Two Spacers may fall off when Safety cover complete is separated from Blade case.

Be careful not to lose them.

3) By unscrewing two M5x16 Countersunk head screws, Bearing box section can be removed by hand. (Fig. 8)

If cannot be removed by hand, lever off using a pair of 1R263 as illustrated in Fig. 8A.

Note: It is recommended to use cordless impact driver for removing the screws because threadlocker is applied to them.

Fig. 7

Tension spring 3

Spacer

Retaining ring WR-26

Blade case

Thickness ring

Spacer

Safety cover complete

Fig. 6

Base

Fig. 8

Bearing box section

Countersunk head

screw M5x16

Fig. 8A

Bearing box section

1R263

Depth guide

30 degrees

centerline of Handle

Lever 40

P 4 /13

1R263