KitchenAid 9752913 Installation Instructions - Page 5

Browse online or download pdf Installation Instructions for Ranges KitchenAid 9752913. KitchenAid 9752913 5 pages. 30"

If range does not
operate:
q
Check that the circuit breaker is not tripped or
the house fuse blown.
q
See Use and Care Guide for troubleshooting
list.
If you need assistance:
If you have questions about operating, cleaning or
maintaining
your range:
q
Refer to Use and Care Guide.
q
Call the Consumer Assistance Center. Check
your Use and Care Guide for a toll-free number
to call or call the dealer from whom you
purchased this appliance. The dealer is listed in
the Yellow Pages of your phone directory
under "Appliances - Household -Major
-
Service and Repair."
If you need service:
Maintain the quality built into your range by
calling an authorized service company.
To obtain the name and number of the authorized
service company:
q
Contact the dealer from whom you purchased
your range; or
q
Look in the Yellow Pages of your telephone
directory under "Appliances - Household -
Major - Service and Repair;" or
q
Call the Consumer Assistance Center.
The toll-free number is listed in your Use and
Care Guide.
When you call, you will need:
q
The range model number.
q
The range serial number.
Both numbers are listed on the model/serial rating
plate located on the oven frame behind the oven
door.
Part No. 9752913
0 1998 Whirlpool Corporation
Moving the range:
Tip Over Hazard
A child or adult can tip the range and
be killed.
Connect
anti-tip
bracket to rear range
foot.
Reconnect
the anti-tip
bracket, if the
range is moved.
Failure to follow these instructions
can
result in death or serious
burns to
children
and adults.
Benton Harbor, Michigan 49022
When moving range, slide range onto cardboard or
hardboard to prevent damaging the floor covering.
If removing the range is necessary for cleaning or
maintenance:
1. Disconnect the electrical supply.
2. Slide range forward to complete cleaning or
maintenance.
3. Make sure the anti-tip bracket is installed:
l
Look for the anti-tip bracket securely attached
to floor.
l
Slide range back so rear range foot is under
anti-tip bracket.
4. Check that range is level.
5. Reconnect the electrical supply.
Printed in U.S.A.