James Burn Koilmatic Quick Setup Instructions - Page 2
Browse online or download pdf Quick Setup Instructions for Binding Machine James Burn Koilmatic. James Burn Koilmatic 2 pages. Automatic tabletop coil inserter & crimper
Print Page
6) Adjust book clamp position
- The book clamp has two settings
step is to set the pre-stage position of the machine. Loosen the
adjustment knob on the side of the book clamp gauge and place the
binding edge of the book into the gauge (Image 5). Bring the clamp
down so it's resting on the book then re-tighten the knob.
nd
The 2
step is to adjust the book clamp comb. Place the book onto
the installed spine formers and jog the book against the sidelay.
Looking at the book clamp comb, you'll notice that the comb has 4
wider tooth gaps. Loosen the thumbscrews on the front of the book
clamp and slide the clamp left or right so that the installed spine
formers clear through those gaps when the book clamp is pressed
down against the positioned book. Then make sure that the teeth of
the comb are between the punched holes (Image 6), a little closer to
the left edge of each hole. This setting provides clearance for the coil
as it inserts into the book. Once correctly positioned, re-tighten the
thumb screws.
Important Note: Before proceeding to step 7, you must first insert a coil into the book. Turn the machine power on, switch the
m
achine to Set-up Mode and close the front cover. Place a punched book on the spine formers making sure it is position and
jogged against the sidelay. Now press the Manual Step button once (this engages pre-stage). Place a piece of coil on the rubber
roller and press the Manual Step button once more to fully engage the book clamp. Press the Manual Step a third time to insert
the coil into the punched book.
7) Position cut and be
- The cut and bend heads cut the
insertion, and crimp the ends so th
book. With the book still clamped, loosen the locking clamp handles
that secure the cutting and bending heads. This will allow you to slide
them from side to side. The left side cut and bend head will only need
to be moved slightly between jobs. The Koilmatic has convenient
preset mounted blocks to allow you to quickly position the right side
cut and bend head for the common 8.5" – A5 – 11" – A4 binding
edges. For an 8.5" or A5, binding edge, slide the assembly against
the left mounted block. For an 11" or A4 binding edge, slide the
assembly against the right mounted block (Image 7).
8
) Ad
just flap feeders
- The flap feeder block h
spin as the coil drives
through. Loosen the thumbscrew that secures the flap feeder block
and slide it so it is positioned in the middle of the two cut & bend
assemblies. Once it's in position, tighten the thumbscrew (Image 8).
9
) Place coil stop
- The coil stop prevents the coil from inserting too far through the
book. The coil st
approximately 1/2" to the right of the book. Secure by tightening the
thumbscrew. This ensures that at least half of the offcut coil will be on
each side of the book, a setting that improves machine efficiency
(Image 9).
that need to be adjusted. The first
nd heads
coil to the proper length after
at the coil can't back out of the
as 2 rectangular shaped pieces of rubber that
into the book, assisting the coil as it travels
op is positioned by clamping it onto the book clamp
Image 5
Image 6
Image 7
For A4 / 11"
For A5 / 8.5"
Image 8
Image 9