James Loudspeakers M1000 User Manual - Page 5
Browse online or download pdf User Manual for Amplifier James Loudspeakers M1000. James Loudspeakers M1000 20 pages. 1000w (4/8 ohm and 70v) dsp subwoofer amplifier
Print Page
Removing the binding post insulators
(3)
If you haven't done so, verify that the amplifier's AC ma ins selector on the rear of the M1000 is set to your
AC line voltage and you have the correct fuse installed.
(4)
Verify that the rear power switch is in the off posit ion. Plug the power cord into the rear IEC connector on
the rear of the amplifier. Connect the other end of the AC cord to an AC power wall socket.
(5)
Once all the input, output and power cables are connected, turn the unit on and proceed with the DSP
setup.
REMOTE CONTROL
Power on/off
Volume down
(DSP left-right when Menu button pressed)
Select "User" EQ setting
Exit navigation mode
The remote control duplicates the functions of the 5 button controller on the front of the M1000, plus adds some
additional functions such as power on/off, mute on/off, and 1 button selection of the 5 EQs. In a typical home
theater installation however, the remote will most likely NOT be used as the M1000 will be configured to a specific
subwoofer and room placement, and controlled by the main processor or receiver.
IR CODES
For a complete set of codes, please go to our website at www.Jamesloudspeaker.com and download from the
M1000 page listed under Products > Electronics > Amplifiers > M1000 Sub-Amp.
Inserting banana plugs into wire holes
Mute button
Menu button - switches five button
cluster to act like the 5 button
navigation on the front of the
amplifier.
Volume up
(DSP left-right when Menu button pressed)
Select EQ Presets 1 through 4
Page 5