Makita BFL400F Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Power Tool Makita BFL400F. Makita BFL400F 17 pages. Cordless angle screwdriver
Also for Makita BFL400F: Technical Information (13 pages), Instruction Manual (13 pages), Instruction Manual (10 pages)

Print Page

1. Screw

1. Angle head

2. Ring

3. Scale

4. Compression spring

5. Yellow line

6. Hole for adjusting grip

7. Adjusting grip

Adjusting the fastening torque

005750

When you wish to drive machine screws, wood screws, hex

bolts, etc. with the predetermined torque, adjusting the fas-

tening torque as follows.

1. First remove the battery cartridge from the tool.

2. Loosen and remove the screw that secures ring.

3. Rotate the ring in the front of the tool by hand so that a

hole can be seen below the ring.

005740

4. Place the battery cartridge in place and pull the switch

005741

trigger. Release it so that the adjusting ring rotates and

becomes visible in the hole. And then remove the battery

cartridge.

5. Use an optional adjusting grip to adjust the fastening

torque. Insert the pin of the adjusting grip into the hole in

the front of the tool. And then, turn the adjusting grip

clockwise to set a greater fastening torque, and counter-

clockwise to set a smaller fastening torque.

6. Align the edge of the adjusting ring with your desired

number on the fastening torque scale.

7. Insert the battery cartridge and be sure that a fastening

torque has been set up by using a fastening torque

tester.

8. Rotate the ring so that the hole for adjusting grip is cov-

ered, hold and then secure the ring with screw.

NOTE:

•

Numbers on the fastening torque scale is a guideline to

set up your desired fastening torque.