GARCARE GPCS06 Instruction Manual - Page 12

Browse online or download pdf Instruction Manual for Pole Saw GARCARE GPCS06. GARCARE GPCS06 15 pages. Corded pole saw

Print Page

Technical data

Model

GPCS06

Before starting up

 Before commencing work, always check that the chainsaw works properly and is

safe to operate.

 Using Bar and Chain Oil (available from your local hardware store) carefully fill the oil

tank to approximately halfway on the oil tank window, always maintaining close to

this level.

 Checking the chain lubrication system, carefully switch the chainsaw on and hold it

above the ground. Be careful not to allow the chainsaw to touch the ground. For

safety reasons it is best to keep a clearance of at least 20 cm. If you see growing

traces of oil, the chain lubrication system is working correctly. If there are no traces of

oil at all, try cleaning the oil outlet hole located behind the bar and check the bar and

chain for debris blocking the flow of oil. Also make sure the oval shaped seal is in

place between the oil outlet hole and bar.

 Check the chain tension and retention, if necessary.

Starting up the machine

1）Assembly of the telescopic chain saw/assembly of the telescopic tube

See Fig. B

Put the telescopic tube to the opening engine head, and then tighten the screw to the

engine head. You can loosen the locking knob for length adjustment completely and

push the telescopic tube to the desired length, finally tighten the locking knob firmly.

2）Assembly and use of the shoulder strap

See Fig. D

Use your thumb or fingers to squeeze the safety lock piece, put the hook to the hanging

part of the tool.

Move slide buckle to adjust the length of the shoulder strap. Adjust the length of the

shoulder strap to obtain a comfortable working position. A few practices swings without

starting motor should be made to determine correct balance.

Put the shoulder strap over your right shoulder. Carry the tool engine at the right side of

your body.

3）Adjustment of engine head

See Fig. E

Press the angle adjustment button for engine head adjustment and adjust the engine

head until it snaps into the desired position.

Rated Rating

120V~60Hz 6.5A

Bar length (inch)