BEROTEC CUMPAN User Manual - Page 5

Browse online or download pdf User Manual for Measuring Instruments BEROTEC CUMPAN. BEROTEC CUMPAN 8 pages. Ktm exc 250-f exc 350-f 250 exc tpi 300 exc tpi / husqvarna fe 250 te 300i fe 350 tx 300i te 250i / gasgas ec 250f ec 300 ec 350f ex 250 ec 250 ex 300
Also for BEROTEC CUMPAN: User Manual (8 pages), User Manual (4 pages), User Manual (9 pages), User Manual (4 pages), User Manual (4 pages)

Print Page

INSTALLATION

Visit our website for more information:

h t t p s : // b e r o t e c . d e /p r o d u c t - c a t e g o r y/c u m p a n - e n / ? l a n g = e n

E l e c t r i c a l c o n n e c t i o n

Power cable: red to switched +12V / black to ground. Often already prepared on

the vehicle (e.g. for a navigation device, called „ACC2" at KTM), otherwise the pow-

er supply of the light / horn is used for this. Current requirement: 80 mA / 12V.

Speed signal: connect black (single) cable to the signal of the crankshaft position sen-

sor. To do this, you need to locate the cable of the sensor. As a rule, this can be found

on the alternator.

Do not lay the cable in the direct vicinity of the ignition system

Engine temperature: Connect plug with sensor. The temperature sensor must

be screwed in/ installed in the area of the desired temperature detection..

Gear indicator: Connect the black and white cable to the cable of the gear sensor.

For this purpose, the cable of the gear sensor must be located. The cable may only be

connected to voltages of 0 - 5V.

Attention: Higher voltages destroy the device!

If no gear signal is connected, the gear indicator on the display is automatically hid-

den.

English