Frisco 156786 Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Pet Care Product Frisco 156786. Frisco 156786 4 pages. End table litter box enclosure

Print Page

STEP 1a

Locate the door panel with entrance hole (#3) and

stand upright. This will be the front door. Place the screw (A) through

the hole from the back, located on the left side of the panel. Now

fasten the door handle (H) using the screw and tighten fully.

STEP 1b

Locate the 4 small holes at the top and bottom of

the door. Take the two metal hinges (D & E) and use the 4 small

screws (F) to attach them to the back of the panel.

STEP 1c

Locate the remaining 2 holes on the back of the door.

Attach the metal plate (I) using 2 small screws (F) and tighten fully.

STEP 3

Lay left-side panel (#1) on a flat surface with the

threaded holes facing up. Insert 4 cam lock bolts (C) into the

threaded holes located at both ends of the panel. Tighten the

cam lock bolt using a screwdriver, do not over tighten. Repeat

tightening the 4 cam lock bolts for the right-side panel (#6).

STEP 5

Find the door panel (#3) and align the metal hinge

with the hole on the metal triangle plate on Shelf panel (#2).

Align opposite metal hinge with hole on the metal triangle plate

on the bottom panel (#4). Hint—wiggle the shelf and bottom

panel slightly to ensure the hinges are engaged in the holes.

Close the door (magnet will hold door in place).

STEP 4a

Align the wooden dowels on the shelf panel installed in step 2b with

the holes on the left-side panel. Hint—the pre-installed magnet

should be facing away from the cam lock holes.

STEP 4b

cam lock bolts on the left-side panel and push down lightly. Hint—

the pre-installed metal triangle plate should be facing toward the

shelf panel.

STEP 4c

panel (#2) and turn cam locks clockwise to secure. Repeat the same

for the bottom panel (#4).

STEP 6

(#5) and insert 4 wooden dowels into all 4 holes. Attach the

bottom trim by aligning the dowels with the 2 holes to the

bottom of the left panel (#1). on the back of the enclosure.

Available exclusively at

STEP 2a

Grab the bottom panel (#4). Locate the outer holes

on each long side and insert 2 wooden dowels (B). Repeat for the

other side.

STEP 2b

Grab the shelf panel (#2). Locate the outer holes on

each long side and insert 2 wooden dowels.

Place the left-side panel (#1) on a flat and clean surface.

Align the wooden dowels in the bottom panel and the

Insert 2 cam locks (G) into the bottom side of the shelf

Locate the 2 holes on each side of the bottom trim

1-800-672-4399